The door should stop and reverse direction within 2 seconds to the fully open position when it contacts the board.Close the garage door using the wall control. With the garage door open, lay a 2 by 4 board flat on the floor at the center of the door opening.Press and release the wall control button and allow the garage door to travel and stop at the UP limit.Press and release the wall control button and allow the garage door to travel and stop at the DOWN limit.The door must complete one full cycle before the settings are automatically recorded. The force controls are set automatically when the wall control is used for the first time with a garage door opener. Both LEDs will flash blue then go out.įorce control refers to how much power is needed to open/close a particular door and doesn’t require programming.
0 Comments
Leave a Reply. |